Mounting of the Controller and Dew Point Sensors
Mount the controller in a interior location near the mixing valve and PT100 temperature
sensor fitting, and away from any exposure to water or dirt. Mounting tabs are located on
the control box on each side. This location may be near the buffer tank, or near the
manifolds.
NOTE: neither the controller or dew point sensors are water proof. It’s also recommended
to consider access to a wall outlet (110-120vac). The controller is powered by a 110-120
wall outlet plug.
Sensors
Mount each sensor in each area where you wish to monitor the dew point. The sensors
have mounting tabs on each side just like the control box. The wire connector can go in two
different ways. First method is to drill a hole in the wall and slide the connector through the
back of the sensor box, it is an oval shaped hole. The short end of the housing “vents” can
also be pushed out with your fingers to run the sensor wire through if you wanted to mount
the sensor on the celling or along side a wall. Note these vents are designed to
“breakaway” so they are relatively fragile. Be careful and don’t break them by accident.
10
