operation manual
Status: 11/2021 - Version 1.01
Page 3
Item No. 23164
3. Setting or programming directly on the timer
Time and day setting: Press and hold the "Clock" button. In addition, press the
D + button. In the upper part of the display, the days of the week are switched
through each time you press D +. Select the currently valid weekday. Keep the
clock button pressed and set the hours (24h) and the minutes one after the
other by pressing H + and M +. After releasing all buttons, the set data will be
saved.
4. Programming the switching times:
There are 8 switch-on times (ON) and 8 switch-off times (OFF). Press the P key
to program. It starts with switch-on time 1 (1 of 8 possible). Use D + to set the
day (s) of the week for which the start time is to be used. Here, each day can
be selected individually or specified day blocks (combinations) or switched
through. The following blocks (combinations) can be selected: Mo Tu We Th Fr
Sa Su • Mo Tu We Th Fr • Sa Su • Mo We Fr • Mo Tu We Th Fr Sa • Tu Th Sa • Mo
Tu We • Th Fr Sa •. Days of the week are shown in English in the display.
Monday (Monday = Mo), Tuesday (Tuesday = Tu), Wednesday (We), Thursday
(Thursday = Th), Friday (Friday = Fr), Saturday (Saturday = Sa), Sunday (Sunday
= Su).
Once you have made all the entries for start time 1, complete the entry by
pressing the P key. Start time 1 is saved and the display changes to switch-off
time 1 (OFF) .. Here you also make all entries (D, H, M) and save again by
pressing P. Now the display changes to start time 2. Make an entry> Press P >
Switch-off time 2> make an entry
> Press P etc., if required up to start / switch-off time 8.
You can exit the programming mode at any time by pressing the "Clock"
button; all entries that have not been confirmed with P will then be lost.
All programmed programming can be "switched through" with the P key and
checked if necessary. Each start or switch-off time can simply be "overwritten"
by "navigating" to it by pressing the P button and simply changing the set
time with the D +, H +, M + buttons. The changed entry must be ended again
with P to save.
Reset / factory setting:
If you want to delete all entries (programming and time), hold down the RESET button with a small object for> 5
seconds. The red ON LED lights up, all entries have now been deleted.
Important instructions:
Make sure you never overload the timer. Maximum 8A (1800Watt). If the relay contacts are overloaded (e.g. by
starting currents or similar), they can "stick" and the device is defective. In this case, the ON / OFF LED no longer
works correctly and the status cannot be checked.
Reproduction only with permission from
ChiliTec GmbH, Bäckerberg 12, 38165 Lehr
EAR (WEEE): DE25841852
LUCID Packaging Act: DE5562476395648
GRS (UBA register) no .: 21003466
