ASSEMBLY / OPERATING INSTRUCTIONS
To install Safety Gate (continued)...
17
18
19
20
21
Adjust locking latch spindles (N) until they fi t securely
into both latch brackets.
Top spindle must click under locking latch when in the
closed position.
Space between end of gate and mounting surface
on locking side may be no less than 25mm and not
more than 70mm.
If adjusting the spindles does not achieve the correct
length, it may be necessary to lift gate off hinges and
readjust the sections (see step 3).
Check that gate can be smoothly opened and
closed.
Place spring (E) on lower hinge post.
Place lower hinge cap (F) on lower hinge and push
down until it clicks into locked position.
Using Phillips head screwdriver, tighten all screws and
screw sockets.
With wrench (P), securely tighten all 4 lock nuts toward
the gate.
17a.
17b.
17c.
18a.
18b.
19a.
20a.
21a.
21b.
ASSEMBLY / OPERATING INSTRUCTIONS
To install Safety Gate (continued)...
22
23
To open gate, press down on locking latch with thumb
and lift gate out of upper and lower brackets.
To lock gate, top locking latch spindle must click under
locking latch and bottom latch spindle must rest in
bottom bracket as shown in fi gure 17.
Temporary removal
The gate may be removed by pressing back on the
locking tab on top of lower hinge bottom while sliding
the hinge cap up.
Remove spring and lift gate off top and bottom hinges.
22a.
22b.
23a.
23b.
23c.
Hinge side
Lock side
630mm - 1080mm
IMPORTANT:
Ensure hinge cap cannot be pushed up and is locked in place.
PLEASE NOTE:
gate should always be in the locked position. If gate is open and
excessive pressure is applied, (such as standing or swinging on the gate) structural
damage may occur.
PLEASE NOTE:
For safety reasons, return spring and hinge cap onto hinge post, make
sure cap is locked in place.