ASSEMBLY / OPERATING INSTRUCTIONS
To install Safety Gate (continued)...
8
9
10
11
Hinge side mounting
Screws provided are for mounting directly into wood.
If mounting into brick, drywall or other surfaces, use
appropriate hardware.
If installing into hardwood (i.e. oak), drilling a pilot hole
may be necessary.
Cut out templates along all dotted lines, separating
template (A) from (B).
Hold template (A) vertically and completely
outstretched against mounting surface with the end
marked ” ” even with the floor.
Mark screw hole positions.
Remove the template.
Use longer screws for mounting into studs behind
drywall.
Using 2 wood screws (K), mount upper hinge (G) (with
hole pointing up) in top 2 screw hole positions.
Using 2 wood screws (K), mount lower hinge bottom
(C) (with post pointing up) in bottom 2 screw hole
positions.
Locking Side Mounting
Screws provided are for mounting directly into wood.
If mounting into brick, drywall or other surfaces, use
appropriate hardware.
If installing into hardwood (i.e. oak), drilling a pilot hole
may be necessary.
Hold template (B) vertically and completely
outstretched against mounting surface with the end
marked ” ” even with the floor.
Mark 4 screw hole positions. Remove the template.
8a.
8b.
8c.
8d.
8e.
8f.
8g.
8h.
9a.
9b.
10a.
11a.
11b.
11c.
11d.
11e.
11f.
ASSEMBLY / OPERATING INSTRUCTIONS
To install Safety Gate (continued)...
12
Determine which direction the gate should open.
For the top of stairways, gate should never open out
over stairs.
Insert stop pins (O) from behind in holes of locking
latch bracket (L) and lower latch bracket (M) opposite
desired opening direction.
12a.
12b.
12c.
13
14
15
16
Use longer screws for mounting into studs behind
drywall.
Using 2 wood screws (K) mount locking latch bracket
(L) in top 2 screw hole positions.
Using 2 wood screws (K) mount lower latch bracket
(M) in bottom 2 screw hole positions.
Centre gate in opening. Adjust upper hinge spindle
(H) so post fits into upper hinge hole (G).
Adjust lower hinge spindle (D) so end fits over lower
hinge post (C).
Space between end of gate and mounting surface
on hinge side may be no less than 31.75mm and not
more than 63.5mm.
13a.
13b.
14a.
15a.
16a.
16b.
IMPORTANT:
The gate cannot open to the stop pinside.