5
STEP 4
Figure 4
AB20030_G8
G
F
K
G
and
F
are
shown installed
on this assembly.
F
G
Attach the second Stationary Side Assembly (K)
following the same process described in earlier
steps. Use a total of four (4) Connector Nuts (F)
and a total of four (4) Allen Head Bolts (G). Tighten
all areas securely using Allen Wrenches (A).
See Figure 4.
Figure 5
STEP 5
AB20030_G9A
H
Follow this
process to
install an Allen
Bolt
H
at each
of the four
corners of
Spring
Assembly
N
.
Pouches are on top
surface with printed
text facing up.
.Assistance by a second person is recommended for
this step.
There are two (2) possible height locations for
Spring Assembly (N). Select the height which is
appropriate for the child. Refer to warning before
installation for additional information. Angle Spring
Assembly (N) (from Step 1) carefully down into crib
as shown in upper diagram.
Attach all four (4) Brackets (C) and (D) at the same
height as shown in lower diagram. Allen Head Bolts
(H) will thread into a factory installed threaded
insert. Tighten each Allen Head Bolts (H) securely
with Allen Wrenches (A).
To adjust height of Spring Assembly (N), remove
all four (4) Allen Head Bolts (H). Then move Spring
(N) to the other height adjustment location. Reinstall
Allen Head Bolts (H) at this location following the
same process outlined in this step above.
See Figure 5.
