Installation Instructions
XFA1U
13
6.
Route cables from display through inside of column
assembly attaching at cable management attachment
points and/or accessory bracket using cable ties (K) or
cable clips (T) as desired. (See Figure 20)
IMPORTANT ! :
Route cables when display is at its
highest point and make sure enough slack exists so that
height may be adjusted without straining the cables!
Figure 20
Adjustments
Height Adjustment
1.
Loosen two stability knobs on either side of head assembly.
(See Figure 21)
2.
Turn height adjustment knob clockwise to raise display.
(See Figure 21)
3.
Turn height adjustment knob counterclockwise to lower
display. (See Figure 21)
WARNING:
Do not attempt to raise or lower the adjustment
carriage beyond its upper or lower limit. High and low points
are shown in Figures 21 and 22.
NOTE:
A 1/2” socket wrench or drill may also be used to adjust
height by turning bolt just above height adjustment
knob.
4.
Tighten two stability knobs on either side of head assembly.
(See Figure 21)
Figure 21
Figure 22
6
6
6
(K) or (T) at attachment
points
2
high point
3
height adjustment knob
1
2
1
4
stability knob x 2
side view
low point
