STMS1U
Installation Instructions
8
Attaching Interface Brackets to Screen
NOTE:
For 100x100mm and 75x75mm hole patterns, the
100x100 adapter must be installed. For all other hole
patterns, proceed ahead to step 2.
1.
(100x100mm and 75x75mm hole patterns ONLY)
Use
four #10-24 X 3/8" Phillips pan machine screws (BB) to
secure two interface brackets (Y and Z) to adapter bracket
(AA). (See Figure 5)
Figure 5
2.
Align the center of the bracket (Y and Z) with center of
screen. (See Figure 6)
NOTE:
The diamond-shape holes in the bracket correspond to
the center of the mount.
WARNING:
IMPROPER INSTALLATION CAN LEAD TO
DISPLAY FALLING CAUSING SERIOUS PERSONAL
INJURY OR DAMAGE TO EQUIPMENT! Using screws of
improper size may damage your display. Properly sized
screws will easily and completely thread into display
mounting holes. If spacers are required, be sure to use longer
screws of the same diameter.
3.
Select correct screws, nesting spacers (if necessary) and
universal washers (if required) from the hardware bag (A-L)
and attach brackets to back of screen. (See Figure 6)
Figure 6
IMPORTANT ! :
The M8 screws do
NOT
require a
washer. Use the universal washer (MB) only with M4, M5
and M6 screws.
NOTE:
The nesting spacers (MA) may be used separately, or
put two together in different configurations to create
different size spacers. (See Figure 7)
Figure 7
(AA)
(Z)
(Y)
(BB) x 4
1
Center of bracket
Pull cord
(MA)
(MB)
(A-L)
NOTE: Use universal washer (MB) ONLY with M4, M5
and M6 screws.
3
(without adapter)
(with adapter)
Pull cord
(A-L)
3
(MA)
(MB)
(Single)
(Nested)
(Stacked)
0.375
[9.5]
0.563
[14.3]
0.750
[19.1]
