Installation Instructions
FWDIW Series
5
Display Installation
The mounting holes on the back of the display will either be
flush with
the back surface, or
recessed into
the back surface.
Refer to the applicable installation procedure below.
Flush Mount Display
WARNING:
IMPROPER INSTALLATION CAN LEAD TO
DISPLAY FALLING CAUSING SERIOUS PERSONAL
INJURY OR DAMAGE TO EQUIPMENT! Using screws of
improper size may damage your display! Proper screws will
easily and completely thread into display mounting holes.
Ensure that screws are not too long.
WARNING:
IMPROPER INSTALLATION CAN LEAD TO
DISPLAY FALLING CAUSING SERIOUS PERSONAL
INJURY OR DAMAGE TO EQUIPMENT! Inadequate thread
engagement in display may cause display to fall! Back out
screws ONLY as necessary to allow installation of Centris
bracket!
1.
Partially install two screws (R1) into upper mounting holes
in display back. (See Figure 4)
NOTE:
Leave at least 1/8" of each screw protruding out back
of display.
Figure 4
2.
Align two screws (R1) in display back with upper teardrop
mounting holes in faceplate. (See Figure 5)
3.
Place two screws (R1) in display back into upper teardrop
mounting holes in faceplate and lower display until screws
are seated in lower area of teardrop mounting holes.
(See Figure 5)
4.
Install two screws (R1) through lower mounting holes in
faceplate and into display back. (See Figure 5)
5.
Tighten all hardware.
Figure 5
Recessed Mount
1.
Place four spacers (R3, R4) over each mounting hole in
display back.
2.
Align teardrop mounting holes in faceplate with holes in
spacers (R3, R4).
3.
Install four Phillips pan head screws (R2) through faceplate
and spacers (R3, R4) and into mounting holes in back of
display.
4.
Tighten all screws.
Figure 6
(R1) x2
1
(R1) x 2
2
3
4
(R3, R4) x 4
(R2) x 4
1
2
3
