background image

Installation Instructions

PWS

1

IMPORTANT WARNINGS AND PRECAUTIONS!

WARNING:

A WARNING alerts you to the possibility of serious injury or death if you do not follow the instructions.

CAUTION:

A

 CAUTION

 alerts you to the possibility of damage or destruction of equipment if you do not follow the corre-

sponding instructions.

WARNING: Improper installation can result in serious personal injury!  Make sure that the structural members can 

support a redundant weight factor 

five times

 the total weight of the equipment:  if not, reinforce the struc-

ture before installing the PWS.

WARNING: Be aware also of the potential for personal injury or damage to the unit if it is not adequately mounted.

WARNING: The installer is responsible for verifying that the wall, to which the PWS is anchored, will safely support 

the combined load of all attached components or other equipment

.

WARNING: The weight of the display placed on the PWS must not exceed 100 lbs. (45.36 kg), the maximum load 

capacity of the PWS

.

WARNING: Watch for pinch points. Do not put your fingers between movable parts.

CAUTION:

Check the unit for shipping damage before you begin the installation.

NOTE:  Hardware for attaching this unit to the wall is not supplied.

TOOLS REQUIRED FOR INSTALLATION

• Electric drill and bit set

• Socket set with extension and open wrenches

NOTE:  Other tools may be required depending on the

       method of installing the lift in the ceiling.

CONTENTS                                                                                            

DIMENSIONAL DRAWING  ........................................

2

INSPECT THE UNIT BEFORE INSTALLING  ............

3

PWS INSTALLATION  ................................................

3

MOUNT THE DISPLAY  .............................................

4

ADJUSTMENTS ........................................................

4

Roll Adjustment  ..................................................................

4

Pitch Adjustment  .................................................................

4

Horizontal Adjustment ........................................................

4

REMOVE THE DISPLAY  ...........................................

4

Summary of Contents for PWS Series






Reviews: