PSMO2085
Installation Instructions
6
ASSEMBLY AND INSTALLATION
Installing Mounting Buttons
1.
Attach four mounting buttons (D) to back of display using
four M8 x 25mm button head cap screws (E). (See Figure 1)
Figure 1
Attaching PSMO2085 to Wall
1.
Place mounting system against wall in desired installation
location.
2.
Level and adjust PSMO2085 making certain slots at upper
and lower edges are properly positioned over studs for
either a 16" on-center wood studs installation (landscape or
portrait) or a 24" on-center wood stud installation
(landscape only). (See Figure 2)
Figure 2
3.
Mark the location of four or six mounting holes onto wall. (See
Figure 2)
Table 1: Fastener Information
4.
Drill four or six pilot holes at marked locations. (See Table 1)
and (See Figure 2)
5.
Proceed to either
Wood Stud
or
Concrete
section for
attachment instructions.
1
(E) x 4
(D) x 4
Display
WALL
TYPE
PILOT
HOLE
FASTENERS (see PARTS
drawing)
Wood
stud
(2" x 4")
7/32" x 3"
5/16 x 3-1/2" hex head lag (G)
& 5/16" washer (F)
. Fasteners
placed at stud locations, min.
16" (400mm) and max. 24"
(610mm).
Concrete
3/8" x 3-1/2"
5/16 x 3-1/2" hex head lag (G)
& UX10x60R anchor (not
included).
Fasteners placed a
min. 16" (400mm) and max. 24"
(610mm)
LANDSCAPE
PORTRAIT
16" on-center attachment points
24" on-center attachment points
16" on-center attachment points
3
x 4 or 6
attachment
points
4
