PSMH2860
Installation Instructions
8
Concrete
1.
Install one UX10x60R anchor (K) into each pilot hole using
a hammer, making sure that the anchor is flush with the wall.
(See Figure 7)
2.
Use one 5/16" x 2-3/4" lag bolt (H) through product into each
anchor in wall.
3.
Repeat for remaining pilot hole(s).
Figure 7
Display Installation
WARNING:
IMPROPER INSTALLATION CAN LEAD TO
MOUNT FALLING CAUSING SERIOUS PERSONAL
INJURY OR DAMAGE TO EQUIPMENT! DO NOT substitute
hardware.
1.
Move latching flag on mount to the
OPEN
position.
(See Figure 8)
Figure 8
2.
Lift display following lifting instructions provided by display
manufacturer.
3.
Align mounting buttons on display with teardrop mounting
holes in mount. (See Figure 9)
4.
Move display forward until recessed area of mounting
buttons is positioned over lower area of teardrop mounting
holes. (See Figure 9)
5.
Lower display until recessed area of mounting buttons is
seated in lower area of teardrop mounting holes.
(See Figure 9)
Figure 9
6.
Move latching flag to
CLOSED
position. (See Figure 10)
7.
OPTIONAL:
Lock latching flag in place, if desired. (See
Figure 10)
Figure 10
8.
Route wires and cables to display.
1
2
(H)
(K)
Latching flag
OPEN
1
[Latching flag on
shown as example only
on landscape version]
5
4
4
Display
6
CLOSED
6
OPTIONAL
added here
(not included)
Padlock
7
