OB1U
Installation Instructions
8
Figure 7
3.
Using the wall assembly (T), mark the wall on each stud
above existing chalkboard/whiteboard through mounting
holes in each bracket. (See Figure 7)
4.
Drill one 1/2" hole at each marked location in wall.
5.
Hold metal channel on anchor (L) flat alongside plastic
straps and slide channel through hole. (See Figure 8)
Figure 8
6.
Holding plastic straps on anchor (L), pull anchor away from
wall until channel rests flush behind wall making sure anchor
channel is positioned vertically on stud. (See Figure 9)
7.
Slide plastic cap on anchor (L) towards wall until flange of
cap is flush with wall. (See Figure 9)
Figure 9
8.
Snap off plastic straps on anchor at wall by pushing side to
side, snapping off straps level with flange of plastic cap.
(See Figure 10)
9.
Repeat Steps 5 through 8 for each mounting hole.
Figure 10
10. Place wall brackets of wall assembly (T) over installed
anchors and align mounting holes in wall brackets with
holes in anchors. (See Figure 11)
11. Insert 1/4-20 x 1-3/4" Phillips pan head screws (
I
) through
1/4" washer (G), corresponding mounting hole on wall
bracket and into anchor (L) and tighten until flush against
wall bracket. DO NOT over tighten! (See Figure 11)
12. Repeat Steps 10 through 11 for remaining mounting holes.
WARNING:
IMPROPER INSTALLATION CAN LEAD TO
MOUNTING SYSTEM FALLING CAUSING SERIOUS
PERSONAL INJURY OR DAMAGE TO COMPONENTS!
Over tightening of mounting hardware can damage the steel
studs. DO NOT over tighten mounting hardware!
Figure 11
3
4
(T)
(L) x 6
Drywall
Plastic Straps
5
(L) x 6
Plastic Cap
Drywall
Anchor Metal Channel
6
Steel Stud
(side view)
7
Plastic Straps
Drywall
Anchor Metal Channel
Plastic Cap
8
Steel Stud
(side view)
Drywall
Anchor Metal Channel
Wall bracket
(
I
) x 6
11
Steel Stud
(G) x 6
(side view)
