MWRSKU
Installation Instructions
8
Display Installation
If the mounting pattern of the display being installed is a VESA
standard 200 x 200 pattern the mounting buttons can be
installed directly to the back of the display. If the display has any
other mounting pattern an interface bracket must be obtained
before proceeding. Consult a Chief Customer Service
representative if an interface bracket is required by calling
1-800-582-6480 or visit www.chiefmfg.com.
WARNING:
IMPROPER INSTALLATION CAN LEAD TO
MOUNT FALLING CAUSING SEVERE PERSONAL INJURY
OR DAMAGE TO EQUIPMENT. Displays can weigh in
excess of 40 lbs (18.1kg). ALWAYS use two people and
proper lifting techniques when installing display.
WARNING:
IMPROPER INSTALLATION CAN LEAD TO
MOUNT FALLING CAUSING SEVERE PERSONAL INJURY
OR DAMAGE TO EQUIPMENT. Make sure mounting buttons
on display are properly seated in mounting holes in faceplate.
To install display:
1.
Move mount faceplate to extended position by grasping
faceplate and pulling outward away from wall.
(See Figure 8)
2.
While supporting both sides of display, align four mounting
buttons on display or interface bracket with four mounting
holes in faceplate. (See Figure 8)
3.
Lower display into place listening for audible "click" to
ensure recessed area of mounting buttons are properly
seated in lower area of mounting holes and "click lock"
mechanism has engaged. (See Figure 8) and
(See Figure 9)
Figure 8
NOTE:
Holes are provided in the faceplate for use with a
padlock or similar locking device, if desired. In addition,
the pin and nut may be removed from the upper holes
and moved to the lower holes for use as a more
permanent locking device. (See Figure 9)
Figure 9
CABLE MANAGEMENT
WARNING:
IMPROPER INSTALLATION CAN LEAD TO
SERIOUS PERSONAL INJURY OR DAMAGE TO
EQUIPMENT! Make sure cables do not run through pinch
points.
1.
Loosen front and rear cable clamps on top arm.
(See Figure 10)
2.
Thread cable ties (K) under cable clamps and secure
clamps to top arm. (See Figure 10)
3.
Route power/audio/video cables through the cable channel
in top arm (See Figure 10), allowing sufficient slack in
cables for left/Right movement of display and swing arm
and also swing arm extension and retraction.
4.
Secure cables to top arm using two cable ties (K).
5.
Repeat steps 1 through 4 for lower arm.
WARNING:
IMPROPER INSTALLATION CAN LEAD TO
SERIOUS PERSONAL INJURY OR DAMAGE TO
EQUIPMENT! DO NOT route cables through holes in
faceplate.
1
3
4
5
4
Remove pin
and nuts and
move to lower holes.
A padlock or bolt may
be placed through latch
holes
