Model: MSP-WRTS1
Installation Instructions
4
ASSEMBLY AND INSTALLATION
Assemble Stand Base
1.
Align mounting holes in R.H. upright (100) with
mounting holes in R.H. base (30). (see Figure 2)
2.
Insert four FHCS (150) through mounting holes in
bottom of R.H.stand base (30) and through mounting
holes in R.H. upright (100).
3.
Secure R.H. upright (100) to R.H. stand base (30)
using four LW (140) and four acorn nuts (130).
4.
Align mounting holes in L.H. upright (100) with
mounting holes in L.H. base (30).
5.
Insert four FLCS (150) through mounting holes in
bottom of L.H.stand base (30) and through mounting
holes in L.H. upright (100).
6.
Secure L.H. upright (100) to L.H. stand base (30)
using four LW (140) and four acorn nuts (130).
Figure 2: Assemble Uprights to Base
7.
Align tapped hole in end of support bar (110) with
teardrop hole in lower R.H.upright (100).
8.
Secure support bar (110) to R.H. upright (100) using
one LW (140) and one HHCS (120). (see Figure 3)
NOTE:
DO NOT tighten hardware at this time.
9.
Align tapped hole in end of support bar (110) with
teardrop hole in lower L.H.upright (100). Once HHCS
has been started, seat cross support bar (110) into
bottom of teardrop slot.
10. Secure support (110) bar to L.H. upright (100) using
one LW (140) and one HHCS (120). (see Figure 3)
11. DO NOT tighten hardware at this time.
Figure 3: Assemble Support Bar To Base
Assemble Faceplate To Stand Base
1.
Align mounting holes in faceplate (50) with mounting
holes on R.H.upright (100). (see Figure 4)
2.
Secure faceplate (50) to R.H.upright (100) using two
FL (170), two LW (140), and two HHCS (120).
3.
Repeat steps 1 and 2 for L.H. side.
4.
Tighten hardware securing faceplate (50) to uprights
(100). (see Figure 4)
Figure 4: Assemble Faceplate to Stand Base
100
30
150
130
140
100
30
110
120
140
100
Faceplate
160
170
140
120
