Installation Instructions
Model: MSP-G1
3
Figure 3: Install Foam Pads
3.
Tilt and lower display so that upper tabs of bracket
(10) fit into upper slots in display (See Figure 4).
Figure 4: Install Display to Upper Bracket Tabs
CAUTION:
Pushing on display screen may result in
damage to your display! Push ONLY on the edge of
the display case.
4.
Grasp back of Centris bracket with one hand, and
push bottom edge of display case with other hand so
that lower tabs of bracket (10) lock into display (See
Figure 5).
IMPORTANT ! :
Visually ensure
both
lower tabs of
bracket (10) have been captured by spring loaded
display locking lugs! (See Figure 5)
Figure 5: Install Display to Lower Bracket Tabs
5.
Connect all cables.
REMOVAL
1.
Remove all cables from display.
2.
While firmly holding display, push the locking lug
release button (See Figure 6). With button
depressed,
tilt
bottom of display out of bracket (10)
and then
lift
display from mount.
Figure 6: Remove Display
30
10
Upper slots in display
Upper tabs of
bracket (10)
10
Display locking lug
(Left side shown;
right side similar)
NOTE: Mount arm not
shown for clarity.
Locking lug release button
