Model: MSP-G1
Installation Instructions
2
IMPORTANT WARNINGS AND CAUTIONS!
WARNING:
A WARNING alerts you to the possibility of serious injury or death if you do not follow the instructions.
CAUTION:
A CAUTION alerts you to the possibility of damage or destruction of equipment if you do not follow the
corresponding instructions.
TOOLS REQUIRED FOR INSTALLATION
•
#2 Phillips Screwdriver
NOTE:
Other tools may be required depending on your
method of installation.
PARTS
After unpacking carton, inspect and verify contents (See
Figure 1). If any listed parts are missing or damaged,
contact Chief Customer Service at 1-800-582-6480.
Figure 1: Parts
INSTALLATION
1.
Using Phillips screwdriver, install four screws (20)
through back side of Centris bracket into bracket (10)
(See Figure 2). Ensure bracket (10) is oriented so that
tabs face away from Centris bracket and cutout is on
bottom.
Figure 2: Install Quick Connect Bracket
2.
If desired, foam pads (30) may installed on inside of
bracket (10) to provide a firmer installation of bracket
(10) to display. Peel backing from foam pads (30) and
install as shown (See Figure 3).
NOTE:
Foam pads (30) may be installed later by
removing display, installing foam, and reinstalling
display.
Table 1: Parts
Item
Description
Qty
10
BRACKET, Dell Quick Connect
1
20
SCREW, Phillips Pan Machine, M4 x 8mm
4
30
FOAM PAD, Adhesive, 4.4" x 0.625" x 0.625"
2
10
20
30
20
(4 places)
Centris bracket
10
Tabs
Cutout
