CHIEF MSP-DCCUST1, Installation Instructions Manual

Page: 10 / 104

MSP-DCCUST1 Installation Instructions
10
6. Tighten four hex head bolts, making sure image is square
with wall. (See Figure 15)
7. Tighten center nut. (See Figure 15)
Figure 15
Leveling the Projector Arm
Tighten the button head cap screw on the arm adjustment plate
(C) to level the projector arm. (See Figure 16)
Figure 16
Adjustments
Height Adjustment
1. Loosen two Phillips screws (one on left, one on right). (See
Figure 17)
2. Turn the button head cap screw on top of mount clockwise
to raise the mount (counterclockwise to lower the mount).
(See Figure 17)
3. Tighten two Phillips screws. (See Figure 17)
Pitch Adjustment
NOTE:
Use a level to make this process easier.
4. Loosen two Phillips screws (one on right, one on left). (See
Figure 17)
5. Tip up or down, as required.
6. Tighten two Phillips screws. (See Figure 17)
Roll Adjustment
NOTE:
Use a level to make this process easier.
7. Loosen one Phillips screw. (See Figure 17)
8. Adjust horizontal tilt, as required.
9. Tighten one Phillips screw. (See Figure 17)
Side-to-Side Adjustment
10. Loosen four Phillips screws (two on front, two on back).
(See Figure 17)
11. Adjust side-to-side, as required.
12. Tighten four Phillips screws. (See Figure 17)
Figure 17
x 4
6
x 1
7
x 1
10 11
12
7 8 9
x 1
4 5 6
x 2
1
x 2
2
OR
x 1
(lower) (raise)
3
x 4