![background image](http://html1.mh-extra.com/html/chief/msp-csc11/msp-csc11_installation-instructions-manual_2601215009.webp)
Installation Instructions
MSP-CSC11
9
3.
Any accessory power cords can be run through the opening
on column behind storage shelf and down through the post
to exit out the back. (See Figure 13)
4.
Route signal cables from display to corresponding devices
in storage shelf. (See Figure 13)
Figure 13
Cable Cover Installation
1.
Place two tabs on underside of Cisco back cover (included
with display) into two holes on bracket on back of column
assembly. This bracket is located just above the cart handle.
(See Figure 14)
2.
Install Cisco back cover onto back of display by pushing it
into position until it snaps into place. (See Figure 14)
NOTE:
If back cover does not fit securely in Step 2, adjust
height of back cover bracket by following Steps 3-5
below.
3.
Loosening screws holding back cover bracket to column
assembly. (See Figure 14)
4.
Adjust back cover bracket height up or down until Cisco
back cover fits securely. (See Figure 14)
5.
Tighten screws holding back cover bracket to column
assembly. (See Figure 14)
Figure 14
3
4
4
3
(rear view of cart)
tabs on underside
of back cover
1
2
back cover
3
4
5
4