Installation Instructions
MPOV
5
Installation
Prepare Mounting Surface and Install Glides
1.
Tape the paper template provided to the mounting surface
in desired location.
2.
Using a 1/4” Drill Bit, drill a hole at each marked location
through template and mounting surface.
3.
Orient left (k) and right (l) glides and place over holes in
mounting surface. (See Figure 1)
IMPORTANT ! :
Make sure the end of the Glide with a
Dowel is facing front.
4.
Insert six button head cap crews (a) through glides, the
mounting surface, and six washers(c). (See Figure 1)
5.
Secure glides to mounting surface using six 1/4-20 Nuts (b).
(See Figure 1)
Figure 1
Adjust Mount Outward Extension
The mount is designed with three maximum outward extension
positions. The mount is shipped from the factory with the
maximum outward extension set at pin position "A".
(See Figure 2) and (See Figure 3). If outward extension is
going to be changed it must be done before continuing mount
installation.
WARNING:
REMOVING STOP PINS WITHOUT
PROPERLY ANCHORING THE MOUNTS SUPPORTING
STRUCTURE CAN LEAD TO DISPLAY TIPPING CAUSING
SERIOUS PERSONAL INJURY OR DAMAGE TO
EQUIPMENT! The cabinet or armoire supporting the mount
MUST be properly secured to a wall or similar structure
capable of supporting the weight of the mount and all
attached equipment in the fully extended position!
Figure 2
Figure 3
1
2
X6
(A) X6
3
(C) X6
(B) X6
X6
1
X2
Stopping Pin
Location "A"
Stopping Pin
Location "B"
Front
Stopping Pin
Location "A"
Stopping Pin
Location "B"
8.0" (203mm)
max. extension
5.5" (140mm)
max. extension
Front
Front
