![background image](http://html1.mh-extra.com/html/chief/mi300i/mi300i_complete-manual_2600315018.webp)
18
MI300I 220V
EN
INSTALLATION – PRODUCT OPERATION
Only qualified personnel authorised by the manufacturer should perform the installation of the welding equipment. During the installation, the
operator must ensure that the machine is disconnected from the mains. Connecting generators in serial or in parallel is forbidden.
EQUIPMENT DESCRIPTION (FIG-1)
This machine is designed to carry out the car body repair operations described below :
- spot welding on sheets using a pneumatic clamp,
- welding of sheets using a gun,
- welding of nails, rivets, washers, studs, mouldings,
- repair of bumps and impacts (hail impacts with the pliers option).
1-
SD card reader
6-
Fan
2-
Interface (MMI)
7-
Breaker
3-
Cooling unit
8-
Power cord
4-
Overhanging arm locking support
9-
Filling cap
5-
Regulator
10- Cooling liquid gauge
DESCRIPTION OF THE G CLAMP (FIG-2)
1-
Arm locking/unlocking lever
7-
Side handle
2-
Cooling pipe
8-
Locking latch
3-
Gyroscope
9-
Gyro lock/unlock mechanism
4-
Pneumatic body
10-
Over-opening button
5-
Over-opening electrode
11- Spot welding button
6-
Mobile arm
12-
Remote settings button
Clamp opening :
push the button (FIG 2 - 10), the opening of the clamp can be released. The electrode retracts in the clamp leaving a space of
80 mm to access the welding area instead of 20 mm when not in use.
ACCESSORIES AND OPTIONS
Coolant CORAGARD CS
330 - 10 l
40 caps
x 10
x 18
x 18
x 6
Protective cover
SD card inclu-
ding automatic
programs
Overhanging
balancing
system
10>14 kg
CEL052246
CEL048935
CEL050068
CEL050853
CEL050914
CEL059696
Caps sharpener
Pressure sensor
Welding test case
Europax anti-corrosion
CEL048966
CEL052314
CEL050433
CEL052758
POWER SUPPLY
• This equipment is designed for use only on a three-phase electrical installation between 200 V and 240 V (50-60 Hz) with four wires and a neutral
connected to earth with a 60 A circuit breaker delayed curve D (or fuse type aM).
The permanent current absorbed (l1p or ILp) displayed in the section «technical specifications» of this manual relates to use at maximum power.
Check that the power supply and its protection (fuse and/or circuit breaker) are compatible with the current needed by the machine. In some
countries, it may be necessary to change the plug to allow the use at maximum settings.
• Check the cross-section of the power lead, recommended cross-section is 4x16 mm
2
(4x6AWG). If the electrical cable from the panel is longer than
10 m, use a conductor with a cross-section of 25 mm² (4AWG).