Installation Instructions
LCM1UP
9
Tilt
The ceiling mounts allow -5° to 20° tilt. The ceiling mount can
be locked at 0°, 5°, 10° and 15° tilt.
3.
Loosen two tilt friction screws (located each side). (See
Figure 10)
4.
Adjust tilt as required. Note specific degrees of tilt. (See
Figure 10)
5.
Tighten two tilt adjustment screws if NOT using the 0°, 5°,
10° or 15° settings.
Figure 10
6.
If using the tilt settings of 0°, 5°, 10° or 15°, insert two
10-24 x 1/2" Phillips head screws (Y) and two 10-24 lock
nuts (Z) to lock mount at the specific tilt. (See Figure 11)
Figure 11
OPTIONAL: Security
1.
OPTIONAL
: Add padlock (not included) to each interface
bracket to lock display to ceiling mount. (See Figure 12)
Figure 12
Installing Covers
1.
Install four interface bracket covers (GG) over the top and
bottom of both interface brackets. (See Figure 13)
NOTE:
Be sure to line up tabs inside the bracket covers with
holes on sides of interface brackets. (See Figure 13)
Figure 13
15°
10° 5° 0°
20°
-5°
Tilt
friction
screw
3
4
5
(Z) x 2
(Y) x 2
6
[Example shows
locking tilt at 15°]
(Ceiling mount not shown for clarity)
Padlock
(Optional)
1
1
(GG)
