KWT-110
Installation Instructions
16
WARNING:
IMPROPER INSTALLATION CAN LEAD TO
EQUIPMENT FALLING CAUSING SERIOUS PERSONAL
INJURY OR DAMAGE TO EQUIPMENT! Overtightening of
mounting hardware can damage the steel studs. DO NOT
overtighten mounting hardware!
Figure 28
Horizontal Installation Using Steel Studs
NOTE:
Wall track accessory may be mounted horizontally to
two studs that are 16", 20" or 24" apart.
After determining the site meets the installation requirements:
1.
Identify desired mounting location on wall.
2.
Use a stud finder or similar method to determine location of
studs.
3.
Draw a vertical line down the center of the studs to be used.
(See Figure 29)
4.
Using wall track accessory (A) as a template, mark location
of three mounting holes on wall. Make sure wall track
accessory is level. (See Figure 29)
WARNING:
Only long holes may be used to mount device
on dual studs. DO NOT mount device using the small holes!
5.
Drill 1/2" holes at each marked location. (See Figure 29)
Figure 29
6.
Hold metal channel on anchor (K) flat alongside plastic
straps and slide channel through hole. (See Figure 30)
Figure 30
7.
Holding plastic straps on anchor (K), pull anchor away from
wall until channel rests flush behind wall making sure
anchor channel is positioned vertically on stud. (See Figure
31)
8.
Slide plastic cap on anchor (K) towards wall until flange of
cap is flush with wall. (See Figure 31)
Figure 31
9.
Snap off plastic straps on anchor at wall by pushing side to
side, snapping off straps level with flange of plastic cap.
(See Figure 32)
Drywall
Anchor Metal Channel
SIDE VIEW
(X) x 3
9
Steel Stud
(A)
x 4
4
5
(A)
Plastic Straps
(K) x 4
Drywall
6
Plastic Cap
Drywall
Anchor Metal Channel
SIDE VIEW
(K) x 4
8
Steel Stud
