![background image](http://html1.mh-extra.com/html/chief/kwt110/kwt110_installation-instructions-manual_2600258014.webp)
KWT-110
Installation Instructions
14
Figure 20
8.
Place wall track accessory (A) over anchors and align
mounting holes in display mount with holes in anchors. (See
Figure 21)
9.
Insert 1/4-20 x 1 3/4" Phillips pan head screws (X) through
corresponding mounting hole on wall track accessory (A)
and into anchor (K) and tighten until flush against mount.
DO NOT overtighten! (See Figure 21)
10. Repeat steps 8 through 9 for remaining 5 mounting holes.
Figure 21
Horizontal Installation using Wood Studs
NOTE:
Wall track accessory may be mounted horizontally to
two studs that are 16", 20" or 24" apart.
1.
Use a stud finder or similar method to determine location of
studs.
2.
Draw a vertical line down the center of the studs to be used.
(See Figure 22)
3.
Using wall track accessory (A) as a template, mark location
of mounting holes on wall. Make sure wall track accessory
is level. (See Figure 22)
WARNING:
Only long holes may be used to mount device
on dual studs. DO NOT mount device using the small holes
unless mounting on three studs.
Figure 22
4.
Drill 7/64" holes at each marked location. (See Figure 22)
5.
Install four #12 x 2 1/2" round pan wood screws (R) through
wall accessory holes into the holes drilled in Step 4. (See
Figure 23)
Figure 23
Plastic Straps
Drywall
Anchor Metal Channel
Plastic Cap
SIDE VIEW
6
Drywall
Anchor Metal Channel
SIDE VIEW
(X) x 6
9
(A)
studs
2
3
(A)
(A)
(R) x 4
5