KSA-1022
Installation Instructions
2
DISCLAIMER
Milestone AV Technologies and its affiliated corporations and
subsidiaries (collectively "Milestone"), intend to make this
manual accurate and complete. However, Milestone makes no
claim that the information contained herein covers all details,
conditions or variations, nor does it provide for every possible
contingency in connection with the installation or use of this
product. The information contained in this document is subject
to change without notice or obligation of any kind. Milestone
makes no representation of warranty, expressed or implied,
regarding the information contained herein. Milestone assumes
no responsibility for accuracy, completeness or sufficiency of
the information contained in this document.
Chief® is a registered trademark of Milestone AV Technologies.
All rights reserved.
IMPORTANT WARNINGS AND
CAUTIONS!
WARNING:
A WARNING alerts you to the possibility of
serious injury or death if you do not follow the instructions.
CAUTION:
A CAUTION alerts you to the possibility of
damage or destruction of equipment if you do not follow the
corresponding instructions.
WARNING:
Failure to read, thoroughly understand, and
follow all instructions can result in serious personal injury,
damage to equipment, or voiding of factory warranty! It is the
installer’s responsibility to make sure all components are
properly assembled and installed using the instructions
provided.
WARNING:
Failure to provide adequate structural strength
for this component can result in serious personal injury or
damage to equipment! It is the installer’s responsibility to
make sure the structure to which this component is attached
can support five times the combined weight of all equipment.
Reinforce the structure as required before installing the
component.
WARNING:
Exceeding the weight capacity can result in
serious personal injury or damage to equipment! It is the
installer’s responsibility to make sure the weight of each
component attached to the KSA-1022 wall track accessory
does not exceed 25 lbs (11.3 kg) or the specific weight limit
for the attached mounting device. Additionally, there is a limit
on how many components may be mounted on each bracket
depending on the mounting method. Refer to the table below
for details.
WARNING:
The KSA-1022 wall track accessory CANNOT
be installed horizontally on drywall without the use of wood or
steel studs. The drywall must have a minimum thickness of
1/2".
Two Mount Maximum
Three Mount Maximum
Horizontal, dual stud mounting
Horizontal, triple stud mounting
Vertical, drywall mounting
Vertical, single stud mounting
DIMENSIONS
9.47
240
36.15
918
FLEXIBLE/REMOVEABLE
CABLE MANAGEMENT
COVERS
.88
22
.60 DEPTH FROM WALL
TO ACCESSORY
MOUNTING SURFACE
15
CABLE
MANAGEMENT
CHANNELS
KSA-1022 SHOWN WITH
KWG AND KWK MOUNTS
(KWG AND KWK MOUNTS
SOLD SEPARATELY)
VERTICAL INSTALLATION
4.50
114
.50
13
6.91
176
.25 TYP.
HOLE SIZE
6
10.00
254
16.00
406
20.00
508
32.00
813
KSA-1022 SHOWN WITH
KWG MOUNTS
(KWG MOUNTS SOLD SEPARATELY)
HORIZONTAL INSTALLATION
