Installation Instructions
K3F310
9
Figure 13
Outside Faceplates
1.
Remove hex head bolt from bottom of faceplate assembly.
(See Figure 14)
2.
Slide out removable plate from bottom of faceplate
assembly. (See Figure 14)
Figure 14
3.
Remove faceplate assembly from array arm. (See Figure
14)
To Reattach Outside Faceplate Assembly
NOTE:
Faceplate assemblies may be reattached on the fixed
part of the arm. (See Figure 15)
4.
Place faceplate assembly on array arm at desired mounting
position. (See Figure 15)
5.
Slide removable plate back into slot at bottom of faceplate
assembly. (See Figure 15)
6.
Reinstall hex head bolt removed in Step 1 to secure
faceplate assembly to array arm. (See Figure 15)
Figure 15
Lateral Shift (On Fixed Arm)
NOTE:
The procedure below applies when the outside
faceplates have been attached to the fixed arm. If
outside faceplates are still attached to extension arms,
use the extension arms for lateral shift.
1.
Loosen knob on top of outside faceplate assembly until
faceplate can slide freely along array arm. (See Figure 16)
2.
Adjust lateral position as desired. (See Figure 16)
3.
Tighten knob to secure lateral position. (See Figure 16)
Figure 16
2
3
1
removable plate
1
2
3
removable plate
5
6
4
2
1
3