K3F310
Installation Instructions
8
2.
When arms are at desired pivot position, lock pivot position
by tightening pivot adjustment screws using 5/16" hex key
(N). (See Figure 10)
Figure 10
Height Adjustment
NOTE:
Height adjustment for center display should be set prior
to installing display. Due to the location of the height
adjustment screws for the center display, the center
display will need to be removed in order to adjust the
height. (See Figure 11)
1.
Loosen height adjustment screws for specific display that
will be adjusted. (See Figure 11)
2.
Adjust arm or display to desired height. (See Figure 11)
3.
Tighten height adjustment screws to lock display’s position.
(See Figure 11)
Figure 11
Arm Extension
NOTE:
For smaller displays or if converting to a 2x1 array,
faceplate assemblies may be removed and reattached
to fixed part of the arm. See Faceplate Assembly
Section - Outside Faceplates for details.
1.
Turn arm extension adjustment knob counter-clockwise on
arm to be adjusted. (See Figure 12)
2.
Adjust arm extension as desired. (See Figure 12)
3.
Turn arm extension adjustment knob clockwise on adjusted
arm to lock position. (See Figure 12)
Figure 12
Faceplate Assembly Removal
Center Faceplate
NOTE:
Center faceplate may be removed to create a 2 x 1
display solution.
1.
Remove column cap (D) from array column. (See Figure 13)
2.
Loosen height adjustment screws for center faceplate
assembly. (See Figure 13)
3.
Slide faceplate assembly up through column channel until it
is removed from column. (See Figure 13)
pivot adjustment screws
2
2
2
1
3
1
3
2
1
3
