Installation Instructions
K2C2OFB215
5
Assembly And Installation
Assembly to Office Furniture Rail
IMPORTANT ! :
The K2C2OFB215 is designed to be
installed to Steelcase FrameOne™ office furniture rails.
Do NOT attempt to install this mount to any other type of
office furniture rails!
NOTE:
If mounting holes on displays are recessed, it may be
necessary to install displays prior to installing
assembly. Proceed to Display Installation Section prior
to installing assembly to rail.
1.
Drop channel plate (E) at an angle into front groove of
FrameOne™ rail. (See Figure 1)
2.
Make sure channel plate (E) lays flat in rail and slide plate
until it is at desired mounting position. (See Figure 1)
Figure 1
3.
Hook back of attachment plate on dual pole mount
assembly (A) into back groove of FrameOne™ rail. (See
Figure 2)
4.
Place dual pole mount assembly onto FrameOne™ rail
making sure holes on attachment plate line up with holes on
channel plate (E). (See Figure 2)
5.
Use two #10-32 x 7/8” flat head cap screws (F) to secure
dual pole mount assembly (A) to channel plate (E). (See
Figure 2)
Figure 2
NOTE:
If mount leans forward after installation, install one or
two shims (G) in between mount assembly (A) and rail
as shown in the following steps.
Installing Shim Spacers (if required)
IMPORTANT ! :
Do NOT install one or both shims (G)
unless required as damage to the FrameOne rail may
result!
6.
Remove two #10-32 x 7/8” flat head cap screws (F) holding
mount assembly (A) to channel plate (E).
7.
Slide one or two shims (G) in between mount assembly (A)
and rail, lining up holes on shim(s) with holes on plate and
rail. (See Figure 3)
8.
Use two #10-32 x 7/8” flat head cap screws (F) to reinstall
mount assembly (A) to channel plate (C). (See Figure 3)
Figure 3
(side view)
FrameOne™ rail
(E)
(E) at final position
1
2
5
3
4
(F) x 2
(A)
attachment plate
(E)
(G) x 1 or 2 (if required)
7
8
(F) x 2
