Instruction Manual
FWV-110
4
Installation
A.
Determine the exact mounting location prior to installation,
considering screen size as well as the mount swing and extension
radius.
B.
Use the wall bracket (90) as a template and drill two 3/32” pilot
holes to a minimum depth of 1 1/2”.
C.
Check wall bracket to ensure it is level and adjust to level if
necessary.
D.
Use two self-tapping screws (80) and two #10 washers (70) to
secure the wall bracket (90).
Flushed Mount or Recessed Mount
NOTE:
This manual contains two sets of Installation Instructions,
listed below. Choose the set of instructions that applies to the
type of installation you want.
•
Flush Mount Applications do not use spacers. The monitor
is attached to the mount with four screws.
•
Recessed Mount Applications use spacers. The monitor
is attached to the mount with four screws and four
spacers.
CAUTION:
If monitor uses a screw size other than those included in the
kit, DO NOT use the screws provided. Using the wrong screws
could result in damage to your monitor.
Flushed Mount
A.
Install two screws (20) in to the top mounting holes of your monitor.
B.
Align the hole-pattern of your display with the screws installed on
the mount and hang the mount from the two screws.
C.
Install two remaining screws (20) through the mount and into the
mounting holes of your display.
Recessed Mount
NOTE:
Use one of the following screw and spacer combinations:
(30 with 40) or (50 with 60).
A.
Select four screws (30 or 50) for the Recessed mount application.
B.
Select the four spacers (40 or 60) for the Recessed mount
application.
C.
Set four spacers (40 or 60) over the four mounting holes on your
monitor.
D.
Install two screws (30 or 50) in to the top mounting holes of your
monitor.
E.
Align the hole-pattern of your display with the screws installed on
the mount and hang the mount from the two screws.
F.
Install two remaining screws (30 or 50) through the mount and into
the mounting holes of your display.
Step 1
Step 3
Step 2
