FVS200 / FVS250
Installation Instructions
6
Figure 4
4. Adjust the shelf from side to side, if necessary, by loosening
the two Nylock lock nuts, moving the shelf and tightening
the lock nuts. (See Figure 5)
Figure 5
NOTE:
Proceed to
Installing Camera
section.
Installing to Wall Mount with Display Removed
NOTE:
Installing the FVS200/FVS250 to a wall mount where a
display has been removed allows use of security
screws to prevent the FVS200/FVS250 from being
removed.
1. Remove display if already attached to wall mount following
instructions included with the wall mount.
2. Hang FVS200/FVS250 on wall mount rail.
3. Adjust location of FVS200/FVS250 and secure to wall
mount rail using one 10-24 x 1" Phillips pan head screw (G).
(See Figure 6)
Figure 6
4. Hang display on wall mount following installation
instructions included with the wall mount.
Installing Camera
1. Install camera to shelf.
NOTE:
If camera has a bottom mounting screw, attach it
through the mounting slot in the shelf. (See Figure 7)
2. Route cable from camera towards back of shelf and down
behind the FVS100/FVS250. (See Figure 7)
NOTE:
Slots are provided in the shelf to allow use of a strap
(not included) to hold camera on shelf. (See Figure 7)
[FVS200 shown]
3
Adjustment
Nut
4
3
(G) x 1
Ergo In Demand, Inc. Contact Information:
4900 Industry Drive
Central Point, OR 97502
800.888.6024 (Toll Free)
541.779.3763 (Office)
541.779.0829 (Fax)
[email protected] (Email)
