KXD220
Installation Instructions
8
For recessed mounting hole installation:
•
Place four spacers (D) on top of mounting holes
on back of display. (See Figure 9)
•
Using Phillips screwdriver, carefully install four
M4x20mm screws (C) through corresponding
holes on faceplate, spacers (D) and into the
mounting holes on the display. (See Figure 9)
Figure 9
4.
Position display with faceplate attached above mount. (See
Figure 10)
5.
Slide faceplate onto mounting head until quick release tab
clicks into place. (See Figure 10)
Figure 10
Adjustments
Low Profile Adjustment
1.
Adjust inside arm to achieve desired low profile depth. (See
Figure 11) and (See Figure 12)
2.
Use 1/8" hex key (L) to adjust low profile tension screws to
change tension. (See Figure 11) and (See Figure 12)
IMPORTANT ! :
Only adjust small set screws on arms!
Large screws are the screws that hold arms together.
(See Figure 11)
Figure 11
Figure 12
(for recessed mounting holes)
(C) x 4
(D) x 4
quick release
faceplate
3
5
tension adjustment
set screws
1/8"
If space is limited in the back
If space is limited in the front
