KXD220
Installation Instructions
10
Display Removal Security Screw
NOTE:
In order to prevent display from being easily removed
from mount using the quick release lever, install
M4x4mm security screw (H) into lower hole on back of
faceplate. (See Figure 17)
Figure 17
Pivot Adjustment Range
1.
Adjust arm angles as desired within a 90 degree range from
the pivot point of the arm and a perpendicular centerline of
mount. (See Figure 18)
WARNING:
Swinging the arm beyond this range may result
in the mount slipping of the desk causing serious injury!
Figure 18
Cable Management
1.
Press insides of cable management covers at both ends to
unhinge tabs on either end of cable management cover on
upper arm. (See Figure 19)
2.
Lift cable management cover up until tabs are unhinged and
cover is in the “open” position. (See Figure 19)
Figure 19
Figure 20
3.
Route cables through cable management channel on upper
arm. (See Figure 20)
IMPORTANT ! :
Be sure to leave enough slack in the
cables near display and arm joint to allow for full arm
articulation!
4.
Close cable management covers on monitor arm. (See
Figure 20)
5.
Route cables through cable clips on lower arm(s). (See
Figure 20)
(M)
perpendicular centerline
90 degrees range
of motion per arm
pivot point of the arm
(top view)
cable management cover tabs
1
2
5
4
3
3
cable (typical)
2
5
