6
Installation Instructions
FHP
CABLE MANAGEMENT
WARNING: Make sure your cables do not run through a pinch
point.
1.
Route power/audio/video cables against column, allowing suf-
ficient slack in cables for extension and avoiding pinch points.
2.
Install top cable cover over cables (see Figure 5).
3.
Measure distance of remaining exposed cables and, using a
saw or appropriate tool, cut lower cable cover to length.
4.
Install bottom cable cover over remaining exposed cables.
ADJUSTMENTS
CAUTION: Overtightening adjustment will cause excessive
wear.
Rotational Tilt, Pitch, and Roll Adjustment
1.
If necessary, use a Phillips screwdriver to tighten or loosen the
Phillips pan head screw (see “DRAWINGS” on page 3).
2.
Check for desired tension.
3.
Repeat Steps 1 and 2 until desired tension is obtained.
Figure 5. Install Cable Cover
