FCASFP / FMSIML / FMSITL
Installation Instructions
10
ATTACH DISPLAYS TO MOUNTING RAIL
WARNING:
IMPROPER INSTALLATION CAN LEAD TO
DISPLAY FALLING CAUSING SERIOUS PERSONAL
INJURY OR DAMAGE TO EQUIPMENT! The displays must
be located approximately evenly across the length of the rail.
1.
Ensure that the latch mechanisms on interface brackets (J
and K) are already raised to the OPEN position. (See
Figure 7)
CAUTION:
BEFORE adding displays to the mounting rails,
ensure end caps (FMSECAP) are in place at BOTH ends of
mounting rail following instructions included with the
FMSECAP.
2.
While supporting both sides of display, lower display onto
mounting rail, hooking top of interface brackets onto top of
mounting rail. (See Figure 7)
Figure 7
3.
Raise latch on interface bracket and close into place against
mounting rail. (See Figure 7)
4.
Fasten latch into place using one 1/4-20 x 1-1/4" socket
head screw (
I
). (See Figure 7)
NOTE:
Socket head screws (
I
) must engage through both
holes to be fully secured. (See Figure 7)
5.
Repeat for each interface bracket on the mounting rail.
Interface Bracket Adjustment
CAUTION:
ALWAYS
keep a small distance between
screens when making adjustments! Damage to screens
possible if placed too close together.
6.
Move displays so that screens are nearly flush and level
with each other.
7.
Use upper knob on back of interface brackets (J and K) to
adjust the height of each display. (See Figure 8)
NOTE:
Adjust both brackets in order to maintain a level mount.
8.
Use middle and lower knobs on back of interface brackets
(J and K) to make plumb adjustments to each display. (See
Figure 8)
Figure 8
1
Latch
4
(I)
x 2
3
NOTE:
Secure
screw (
I
)
through both
holes.
OPEN
Latch
CLOSED
7
8
8
(Display not shown for clarity)
7
