Installation Instructions
CSPHK
3
Assembly And Installation
CSPH Removed Bracket Installation
The CSPHK bracket kit was designed to install partial sections
of the CSPH component storage plate.
1.
Use template drawing included with CSPH to mark
mounting holes on bottom of desk at desired mounting
location. (See Figure 1)
Figure 1
2.
Drill four 3/32" pilot holes are marked locations under desk.
(See Figure 2)
3.
Use four #10 x 3/4" Phillips wood screws (D) to secure two
desk brackets (B) to underside of desk. (See Figure 2)
NOTE:
CSPHK accessory can be installed in either direction
depending on user preference
NOTE:
Any of the nine mounting slots in each section may be
used to mount plate to desk.
Figure 2
4.
Loosely install two #10-24 x 3/4" Phillips pan machine
screws (C) into bottom holes on CSPH desk plate. Two #10-
24 x 1/2" button head security screws (E) may be used in
place of two Phillips screws (C) if greater security is desired.
(See Figure 3)
Figure 3
5.
Slide CSPH desk plate onto back desk bracket (B) until two
screws (C) or (E) sit in slots of bracket (B). (See Figure 4)
Figure 4
6.
Use either two quick release pins (F) or two #10-24 1/2"
button head security screws (E) to secure CSPH desk plate
to front desk bracket (B). (See Figure 5)
Figure 5
7.
Tighten all screws (C) or (E) holding CSPH desk plate to
desk brackets (B).
for two panel use
for single panel use
for all configurations
(under desk view)
CSPH template
(D) x 4
3
(B) x 2
x 4
2
3/32"
(under desk view)
(C) x 2
or
4
(E) x 2
CSPH desk plate
4
(under desk view)
5
5
CSPH desk
plate
(under desk view)
(F) x 2
or
(E) x 2
6
6
