CMSFAN
Installation Instructions
2
DISCLAIMER
Milestone AV Technologies and its affiliated corporations and
subsidiaries (collectively "Milestone"), intend to make this
manual accurate and complete. However, Milestone makes no
claim that the information contained herein covers all details,
conditions or variations, nor does it provide for every possible
contingency in connection with the installation or use of this
product. The information contained in this document is subject
to change without notice or obligation of any kind. Milestone
makes no representation of warranty, expressed or implied,
regarding the information contained herein. Milestone assumes
no responsibility for accuracy, completeness or sufficiency of
the information contained in this document.
Chief® is a registered trademark of Milestone AV Technologies.
All rights reserved.
IMPORTANT SAFETY INSTRUCTIONS
WARNING:
A WARNING alerts you to the possibility of
serious injury or death if you do not follow the instructions.
CAUTION:
A CAUTION alerts you to the possibility of
damage or destruction of equipment if you do not follow the
corresponding instructions.
WARNING:
Failure to read, thoroughly understand, and
follow all instructions can result in serious personal injury,
damage to equipment, or voiding of factory warranty! It is the
installer’s responsibility to make sure all components are
properly assembled and installed using the instructions
provided.
WARNING:
Use this fan kit only for its intended use as
described in these instructions. Do not use attachments not
recommended by the manufacturer.
WARNING:
Never operate this fan kit if it is damaged.
Return the fan kit to a service center for examination and
repair.
WARNING:
Do not use this product outdoors.
NOTE:
Spacings - To ensure safe operation of the equipment
installed in the enclosure, per National Electric Code,
ANSI/NFPA 70 Article 725.136(D)(1), a minimum
separation of 6mm (0.25 in.) between power cords and
signal or communication cables must be maintained.
In the U.S., the equipment shall be installed per the applicable
requirements of the National Electrical Code, ANSI/NFPA 70.
In Canada, the equipment shall be installed per the applicable
requirements of the Canadian Electrical Code, CSA C22.1.
IMPORTANT ! :
The CMSFAN is designed to be installed
in the Listed Chief CMS491-491C-492-492C above-
ceiling suspended storage boxes (not included).
--SAVE THESE INSTRUCTIONS--
DIMENSIONS
DIMENSIONS: INCHES
[MILLIMETERS]
