CMS490
Installation Instructions
10
WARNING:
RISK OF ELECTROCUTION! All electrical
wiring required for installation should be installed by a
qualified electrician.
IMPORTANT ! :
The appropriate outlet being installed
must be the grounding type and properly grounded in
accordance with all local codes and ordinances.
3.
Wire outlet into junction box in accordance with all local
codes and ordinances.
Adding Components
1.
Open and lower door on CMS490.
2.
Loosen, but do NOT remove, four thumb nuts on
component tray. (See Figure 14)
3.
Slide tray and lower to remove from CMS490. (See Figure 14)
Figure 14
4.
Add components to component tray.
5.
Lift component tray to CMS490, ensuring all power and
signal wires and cables are properly installed on the tray.
(See Figure 15)
6.
Slide component tray to narrow end of thumb nut openings.
7.
Fasten tray into place by tightening four thumb nuts.
8.
Close CMS490 door and lock in place.
Figure 15
x 4 thumb nuts
2
3
Component
tray
6
5
7
x 4 thumb nuts
Component
tray
