Chicco 06607, Instructions For Use Manual, Page: 24 / 148

24 25
Remove the run out rechargeable battery (13) and
replace with another rechargeable battery that is
identical to the 3.7V 800mAh supplied with the
product (code 20256400100 to be requested
directly from Artsana S.p.A.) taking care to place
them with the correct insertion polarity indicated
on the battery compartment.
Reposition the battery compartment closing
panel (9), first inserting the lower panel hooks in
their battery compartment housing and gently
pushing the panel toward the product (fig.4).
TECHNICAL SPECIFICATIONS
Child unit (primarily in transmitter mode)
Mod. 06607
Power:
Internal: TWO 1.5V AAA/LR03 ALKALINE
BATTERIES
External: via 100-240V~ 50/60Hz /6V
500mA mains switching adapter
Transmission:
• Transmission frequency band: 2400-2454 MHz
• Signal strength: 100mW max
Parent unit (primarily in receiver mode)
Mod. 06607
Power:
Internal: 3.7V 800mAh LITHIUM-ION BATTERY
External: via 100-240V~ 50/60Hz /6V
500mA mains switching adapter
Lithium-ion battery charging via 100-240V ~
50/60Hz /6V
500mA mains switching
adapter
Reception:
• Transmission frequency band: 2400-2454 MHz
• Signal strength: 100mW max
Mains adapter
Mod. S003IV0600050
INPUT: 100-240V ~ 50/60Hz 150mA
OUTPUT: 6V
500mA
Plug polarity:
Made in China
Lithium-ion battery
Mod. MB1022 (ICP46/34/46)
Nominal capacity: 800mAh (2.96Wh)
Nominal voltage: 3.7V
Lithium batteries give best performance when
used at normal room temperature (20°C±5°C)
Made in China
SYMBOLS KEY
monophase alternate current
direct current
for indoor use only
Class II -
double insulation equipment
Conforms to applicable EC
directives and subsequent
amendments
ATTENTION. Read the instructions
for use
TROUBLESHOOTING
If you experience problems, please first check the following list and check that:
• Both units are on
• Both units are properly connected to the power socket via the mains adapter (1), or that batteries are
charged.
FAULT CAUSE SOLUTION
The parent
unit (receiver)/
child unit
(transmitter)
power
and link
indicator
light (5)
is off
- Child unit (transmitter) and/or
parent unit (receiver) off.
- Child unit Alkaline batteries
(not included) and/or parent unit
lithium-ion battery completely
discharged.
- Mains adapter disconnected or
not connected correctly.
- No mains voltage.
- Switch on the child unit (transmitter)
and/or the parent unit (receiver)
- Replace Alkaline batteries
in the child unit and/or charge
rechargeable lithium-ion battery in the
parent unit
- If the units are powered via mains
adapter, verify that this device is
correctly connected to a mains outlet
- Check that the outlet is being
powered.
The parent unit
(receiver) does
not emit any
sounds.
- No discernible sounds are arriving
to the child unit (transmitter)
- The voice activation function has
been selected
- Parent unit (receiver) volume set
at minimum
- Child unit Alkaline batteries and/
or parent unit lithium-ion battery
completely
discharged
- The parent unit (receiver) may
be off
- Just as soon as discernible sounds
from the environment are present,
the transmitter will be activated.
In any case, for peace of mind, test
transmission with the help of another
person who can try to speak in the
room the child unit (transmitter) is on.
- Check the position of the voice
activation or continuous transmission
ON/OFF selector.
If the selector is set to ON, the voice
activation function is active.
As soon as sounds present in the child
unit environment exceed the threshold
for voice activation, the parent unit will
emit sounds.
- Adjust parent unit (receiver) volume
until sounds are audible, pressing
the + volume adjustment button (3a).
- Replace Alkaline batteries
in the child unit and/or charge lithium-
ion battery in the parent unit
- Switch on the parent unit (receiver)
Interference In rare cases, even if FHSS
technology ensures high immunity
to interference
from analogue devices,
interference can be caused by
the presence of another intercom
or similar transmission device
switched on nearby.
Electromagnetic pollution
(proximity to antennas with radio
transmitters, high
voltage cables, etc.).
Move away from analogue equipment
and/or leave
the area in which it is located.