Page 2
For technical questions, please call 1-888-866-5797.
Item 98958
SAFET
y
W
EL
d
IN
g
C
UTTIN
g
M
AINTENANCE
SETU
p
Table of Contents
Safety ......................................................... 2
Specifications ............................................. 6
Setup .......................................................... 6
Welding ...................................................... 10
Maintenance .............................................. 18
Parts Lists and Assembly Diagrams .......... 19
Warranty .................................................... 24
WARNINg SyMBOLS ANd dEFINITIONS
This is the safety alert symbol. It is used to alert you to potential
personal injury hazards. Obey all safety messages that
follow this symbol to avoid possible injury or death.
Indicates a hazardous situation which, if not avoided,
will result in death or serious injury.
Indicates a hazardous situation which, if not avoided,
could result in death or serious injury.
Indicates a hazardous situation which, if not avoided,
could result in minor or moderate injury.
Addresses practices not related to personal injury.
IMpORTANT SAFETy INSTRUCTIONS
Read all safety warnings and instructions.
Failure to follow the warnings and instructions may result in electric shock, fire and/or serious injury.
Save all warnings and instructions for future reference.
The warnings, precautions, and instructions discussed in this instruction manual
cannot cover all possible conditions and situations that may occur.
It must be understood by the operator that common sense and caution are factors which
cannot be built into this product, but must be supplied by the operator.
Work Area Safety
1.
Keep your work area clean and well lit.
Cluttered benches and dark areas invite accidents.
2.
Keep bystanders, children, and visitors away
while operating.
Distractions can cause you to
lose control. Protect others in the work area from
intense heat. Do not allow others close enough to
look at the flame as eye damage is a real possibility.
Provide barriers or shields as needed.
3.
When possible, move the work to a location well
away from combustible materials.
If relocation
is NOT possible, protect the combustibles with a
cover made of fire resistant material. Remove or
make safe all combustible materials for a radius
of 35 feet (10 meters) around the work area.
4.
Enclose the work area with portable fire
resistant screens.
Use a fire resistant
material to block all openings and protect
combustible walls, ceilings, floors, etc.
5.
If working near/on a metal wall, ceiling, floor,
etc., prevent ignition of combustibles on
the other side by moving the combustibles
to a safe location.
If relocation of combustibles is NOT possible,
designate someone to act as a fire watch equipped
with a fire extinguisher during the welding or
cutting process and for at least one half hour after
the welding or cutting project is completed.
6.
do not place the Torch on any material other
than bare concrete until it has cooled completely.
