Page 9
SKU 93375
For technical questions, please call 1-800-444-3353
ASSEMBLY
The Wet / Dry Vacuum comes assembled. Refer to the operating instructions (below) regard-
ing the Filter Cartridge (6) and Foam Filter (5). Fasten the attachments required, and begin
to work.
OPERATION
Using the Power Switch
The Power Switch (4) is on the top of the Motor Housing (1). There are three switch settings
for operation: ON, OFF, and REMOTE (R). The Remote position is selected when a power
tool is powered by the Auxiliary Electrical Outlet (3). In this mode, when the power tool is
turned on, the Wet / Dry Vacuum will turn on automatically after a few seconds delay. It will
turn itself off again after the power tool is turned off. The Hose (10) is connected to the dust
exhaust port of the power tool (i.e., belt sander).
Caution: The Auxiliary Electrical Outlet (3) can only provide 1000 watts to the power
tool. When the Wet / Dry Vacuum is plugged in, the Auxiliary Electrical Outlet (3) is al-
ways powered on (hot) in all three Power Switch positions.
Using the Wet/Dry Vac with a Power Tool
1.
Connect the large end of Hose (10) to the Suction Port (8) and the other end to the
power tool dust exhaust port.
It may be necessary to use the Hose Adapters (21) to make a tight fit between the end
of Hose (10) and the power tool exhaust port.
Power Switch (4)
Exhaust Air Port (19)
Suction Port (8)
Hose Adapters (21)
Straight Tube (12)
Accessory Tube (13)
Small Brush (17)
Crevice Accessory (18)
Hose (10)
Flat Surface Attachment (22)
Auxiliary Electrical Outlet (3)
Motor Housing (1)
Housing Locks (2)