Page 9
For technical questions, please call 1-800-444-3353.
Item 69696
SAFETY
O
PERA
TION
M
AINTENANCE
SETUP
Setup - Before Use:
Read the ENTIRE IMPORTANT SAFETY INFORMATION section at the beginning of this
manual including all text under subheadings therein before set up or use of this product.
TO PREVENT SERIOUS INJURY FROM ACCIDENTAL OPERATION:
Make sure that the Power Switch is in the off-position and unplug the tool from
its electrical outlet before performing any procedure in this section.
Note:
For additional information regarding the parts listed in the following pages,
refer to the Assembly Diagram near the end of this manual.
Assembly
Installing the Backing Pad
1. Press the Spindle Lock (22) in and hold it down.
2. Thread the Backing Pad (2) firmly
onto the Spindle (3).
3. Release the Spindle Lock.
Installing the D-Handle
TO PREVENT SERIOUS INJURY:
Do not operate this tool with one hand only or
without the Auxiliary Handle properly installed.
1. Attach the D-Handle (18) to the sides of
the Gearbox (24), using the Hex Key (38)
and two Bolts (19) and Washers (20).
2. Slide the Hex Key through the hole in the D-Handle
to access the Bolt on the long side of the D-Handle.
D-Handle
Bolt
Bolt
Washer
Washer
Gearbox
Figure A: D-Handle Installation
Functions
Backing
Pad
Spindle
Lock
D-Handle
Control Panel
(see detail, right)
Power
Switch
Speed
Display
Accelerate
Decelerate
Speed is displayed in 100 RPM increments.
Example: 25 means 2500 RPM.
Summary of Contents for 69696
Page 1: ......
