Page 6
For technical questions, please call 1-888-866-5797.
Item 64527
Operating Instructions
Read the ENTIRE IMPORTANT SAFETY INFORMATION section at the beginning of this
manual including all text under subheadings therein before set up or use of this product.
Before Welding
1. Check that the inside and outside of the lens is clean.
2. Remove any protective film from the
inside or outside of the lens.
3. Before use, inspect all operating parts
for signs of wear or damage.
4. A lens that is scratched, cracked, or pitted
should be replaced immediately.
5. A helmet that is cracked should
be replaced immediately,
6. To avoid personal injury, do not use the
Welding Helmet until repairs are made.
Headband Adjustment
Adjust the Welding Helmet’s work position and
viewing angles that work best for you. The Welding
Helmet should be seated securely on your head
as low as possible and close to your face. The
front lens should be aligned with your eyes.
1. Select the viewing horizontal level by
adjusting the Headband buttons (12).
2. Select viewing angle by adjusting the
Segmental positioning plate (13).
3. Adjust the Headband tightness by pushing and
turning the Headband adjustment knob (11). The
Welding Helmet should fit snug on your head.
Figure A
Headband
Screw (10)
Headband
Tightness
Adjustment
Knob (11)
Segmental
Positioning
Plate (13)
Headband
Adjustment
Buttons
(12)
Sweatband
(14)
Lens
Headband
