Step 4)
Once you have wound the Nylon Line (#5) into place, place the Spool (#4) onto the
Spring (#3). Thread the end of the Nylon Line (#5) through the eyelet in the
Spool Housing (#21). Leave about 5 inches of Nylon Line (#5) beyond the Spool
Housing (#21) so that it remains inside of the Guard (#6) -see Figure 3.
Step 5)
Replace the Cap (#2) on the Spool by inserting Cap so that tabs snap into place.
Spool Cap (#2)
Spool (#4) and Nylon Line (#5)
Spring (#3)
Figure 3-Replacing Nylon Line onto Spool
Operation
To assist you with operation please refer to the Operational Figures as well as the Parts List located
on the last page of this manual.
Handle
Step 1)
To adjust the Handle, loosen the Handle Knob (#13) and rotate the Handle (#11) up
or down into the desired position. Retighten the Handle Knob (#13).
Shortening and Extending Tube
The Top Tube (#10) can be adjusted up or down to shorten or extend the length between the Hand
Grip (#15) and the Guard (#6).
Step 1)
Press the Tube Button (#14) and move the Top Tube (#10) up or down over the
Bottom Tube (#9). Release the Tube Button (#14) when the Top Tube (#10) is in the
desired position-see Figure 4, page 7.
Adjusting the Head
Step 1)
Tilt the Head/Motor Housing (#7) to the desired angle by pushing in on the Head
Adjuster Button (#8). The Head will swivel up and down to the position for best
trimming-see Figure 1.
Step 2)
Release Head Adjuster Button (#8) once Head is at the ideal position.
Line Release Button(#20)
#47944
Page 6
Spool Housing (#21)
