Page 11
for technical questions, please call 1-800-444-3353.
SKU 43150
If there is interference from similar
1.
metal detectors in your searching
area, lower the DISCRIMINATION
and adjust the TUNE setting to stop
the interference. You may also need
to rebalance the Metal Detector.
If there is interference from electrical
2.
cables, TV, radio, or other electrical
devices in your searching area, lower
the DISCRIMINATION setting.
When searching in highly mineralized
3.
areas, the unit may sound even
if there is no metal. Lower the
DISCRIMINATION setting and
increase the distance of the Search
Coil from the ground until the false
signal disappears. You may also
need to rebalance the Metal Detector.
When searching in a trash area, set
4.
the DISCRIMINATION to the middle
setting so that the unit can reject
most invaluable metals such as nails,
bottle caps, cans, and small pieces of
iron.
Move all metal digging tools away
5.
from the Metal Detector when
searching.
maintenance anD
SerVicing
Procedures not specifically
explained in this manual
must be performed only by a
qualified technician.
to preVent
SeriouS injurY
from acciDental
operation: turn the power
Switch of the tool off and
remove the batteries from the
tool before performing any
inspection, maintenance, or
cleaning procedures.
Do not use damaged
equipment. have the problem
corrected before further use.
cleaning and maintenance
Before each uSe,
1.
inspect the
general condition of the tool. Check
for loose hardware, misalignment or
binding of parts, cracked or broken
parts, damaged electrical wiring, and
any other condition that may affect its
safe operation.
Handle the Metal Detector gently and
2.
carefully. Dropping it can damage
circuit boards and the case, and can
cause the Detector to malfunction.
after uSe,
3.
wipe external surfaces
of the tool with a damp clean cloth,
then dry. Do not use harsh chemicals,
cleaning solvents, or strong
detergents to clean the detector.
