SKU 38648
For technical questions, please call 1-800-444-3353.
Page 9
Figure g
3. Place a Crescent Wrench on the
Spindle (1) and firmly hold to prevent
the Spindle from rotating.
(see Fig-
ure g.)
Place the Arbor Wrench (included
4.
accessory) on the Blade Bolt (62) and
loosen counterclockwise to remove
the Blade Bolt.
(see Figure g)
note:
Be aware of the sharp blade; handle
with care.
Slide the Cutting Blade (61) out, not-
5.
ing the direction of the Blade Teeth.
Install the new Cutting Blade (61)
6.
onto the Spindle (1), making sure
the Blade Teeth are facing toward
the right of the Biscuit Joiner.
(see
Figure F.)
note:
Be aware of the sharp blade; handle
with care.
Replace the Blade Bolt (62) and
7.
tighten clockwise until secure.
Reassemble the Adjustable Fence
8.
(64) to the Joiner Base (43) using the
two Allen Screws (67).
To Use The Locking On/Off Switch:
note:
The Biscuit Joiner Switch (35) is
located under the Hold Covers (28,
29). The
orange
Switch Lock Button
on the left side of the Cover locks the
Switch in the “ON” position for long
cutting operations.
(see assy. drawing.)
To turn the Biscuit Joiner on without
1.
locking it in the “ON” position, press
and hold the Switch (35) in. When
pressure is released, the Switch
snaps back to the “OFF” position.
To lock the Switch (35) in the “ON”
2.
position, press and hold the Switch
in. Then, press in the orange Switch
Lock Button on the left Hold Cover
(28).
To unlock the Switch (35) from the
3.
“ON” position, press and release the
orange Switch Lock Button.
rev 02e
