SKU 38648
For technical questions, please call 1-800-444-3353.
Page 10
To Mark Slot Locations For Standard
Cuts:
Figure i
1. Always begin with the Joiner Base
(43) cutting into the end of the wood,
rather than the side.
(see Figures H
and i.)
Mark the center of the slot at a point
2.
at least 2-1/2” from the outer edge of
the board.
note:
Allow at least 1” between slots in
multiple plate applications for best
results. Mark all slots on both boards
at the same time to assure proper
alignment.
Align the center line on the Adjustable
3.
Fence (64) with the pencil mark on
the wood.
(see Figures B and c.)
Hold the Biscuit Joiner firmly with
4.
both hands. Turn the power “ON”
and push the Biscuit Joiner forward
slowly and smoothly.
When the Joiner Base (43) has butt-
5.
ed completely against the wood sur-
face to be cut, pull the Biscuit Joiner
back and turn the power “OFF”.
To Mark Slot Locations For Other Types
Of Cuts:
note:
When making preparations for
cutting slots for T-butt, miter, edge-to-
edge, leg and rail, and square pattern
joints, there are two important steps
to ensure proper alignment of the
joints:
Align all boards as you want them to
a.
appear when finished, then mark the
center line for the slots on all boards
at the same time.
Set the plate depth
b.
before
making
the cuts.
rev 02e
Figure H
