Chicago Dryer Edge MAXX, Instruction Manual

Page: 58 / 288

Preventive Maintenance Edge MAXX
4-2
4.1 Daily PM (8 hours)
WARNING
Do not repair or correct any
of these conditions without
reading and understanding
the Repair chapter.
Only qualified personnel
should troubleshoot and
repair this unit.
Make sure the power is
turned OFF at the main
disconnect switch.
Follow lockout/tagout
procedures approved for
your site. Follow local
regulations. Failure to do so
could result in serious injury.
Watch and Listen for Anything
Abnormal
Perform only when the unit is
RUNNING.
Use extreme caution.
Operators and maintenance personnel should
learn to understand the usual sights and sounds
around a unit. For example, when there is a
noise at a roll, the bearings may be worn or other
mechanical problems may exist. Stop the unit
immediately and follow-up with the necessary
maintenance or repair.
General Cleanliness
It is important to prevent the buildup of lint,
dirt, dust and foreign material in the unit. General
cleanliness prevents damage to components,
jamming and soiling flatwork.
Keep the area as well as the spreader/feeder
as clean as possible.
Required Tools
vacuum cleaner or compressed air,
soft, lint-free cloth.
Perform only when the unit is OFF
with power disconnected.
Turn power OFF at the main disconnect
switch.
CAUTION
NEVER use compressed
air on or around electronic
components.
Damage can result.
Check and clean the below listed items
daily.
Drive shaft rollers and bearings.
Face of the pneumatic clutch/brake
roller.
Between the clutch roller and lower
inlet conveyor belt drive.
Inlet conveyor drive and idler rollers.
Spreader rail, clamps, and grooved
bearings.
Lower spreader belts tension roller.
Ribbons.
General components.
Make sure that there is no lint, tape or
string build-up.
1.
2.
•
•
•
•
•
•
•
•
3.
TOC INDEX