Installation
Edge MAXX
2-4
Uncrating and General Placement
Required Tools
forklift, crowbar, sledgehammer, wire
cutters/knife, wrench
Before unpacking the unit, make sure that
the proposed site is acceptable and any nec-
essary foundations have been prepared.
Remove the crating, strapping, and other
packaging materials from the unit. Leave
the protective plastic covers on the controls.
These protective coverings should be left in
place until the unit is ready for use.
Open both endframe doors and remove any
materials shipped with the unit. Close and
secure the doors.
CAUTION
The unit should only be
moved by qualified riggers
using proper equipment.
With the unit still on its skid, move it into
approximate position. Remove the bolts
which secure the unit to the skid.
CAUTION
Do not drop or twist the unit.
As appropriate:
If the unit is equipped with eye bolts,
lift the unit straight up using the two eye
bolts on top of each endframe and care-
fully remove the skid from under it.
OR
Lift one endframe and carefully re-
move the skid from under it and then
repeat for the other endframe.
1.
2.
3.
4.
5.
•
•
Input Conveyor Installation
For shipping purposes, the machine may have
arrived with the input conveyor disassembled.
Follow these instructions to install the input
conveyor components.
Required Tools
wrench, pliers, plastic wire ties,
scissors/knife
Locate the disassembled input conveyor
parts.
Upper input conveyor belt with con-
necting pin.
Upper input conveyor extension arm.
Lower input conveyor belt with con-
necting pin.
Lower input conveyor extension arm.
Begin with the upper arm (Figure 2-3,
A). On the bottom of the extension arm,
there is a bolt with a spring and two nuts.
These are used to adjust the conveyor belt
tension.
Remove both adjustment nuts but keep the
spring on the bolt.
1.
•
•
•
•
2.
3.
Figure 2-3: Upper input conveyor arm extensions.
A
B
TOC
INDEX
Summary of Contents for Edge MAXX
