Repair
Edge MAXX
7-6
Inlet Conveyor Drive Belt Tension
Adjustment
An inlet conveyor motor is located at each
station, near the top of the inlet conveyor
assembly. The inlet conveyor drive belt tension
adjustment point can be reached from the front
of the unit.
Required Tools
3/16” Allen key, 1/2”, 9/16” wrenches
Perform only when the unit is OFF
with power disconnected.
Turn power OFF at the main disconnect
switch.
Remove the bolts that hold that station’s
inlet conveyor motor cover in place and
move the cover (Figure 7-5, A) so that the
inlet belt (B) can be seen.
Loosen the nuts which secure the inlet con-
veyor motor in position (Figure 7-5, C).
Pull the motor toward you to increase ten-
sion on the drive belt.
Make sure the pulleys are properly aligned
and tighten the bolts to secure the motor
in position.
Replace the inlet conveyor drive motor
cover.
WARNING
Never operate the unit unless
all safety covers are in place
and all safety equipment is
working correctly.
Start the unit to check the adjustment.
1.
2.
3.
4.
5.
6.
7.
Figure 7-5: The bolts which secure the inlet motor
in position are in slotted holes.
A
C
B
TOC
INDEX
Summary of Contents for Edge MAXX
