Chicago Dryer Edge MAXX, Instruction Manual, Page: 104 / 288

Troubleshooting Edge MAXX
6-2
Troubleshooting Symptoms
6.1 CHI Diagnostic Message Index .................................................................... 6-6
6.2 LED Diagnostics ............................................................................................ 6-8
6.3 Electrical
Unit Does Not Start, No Message Displayed ..................................................................... 6-9
Unit Does Not Start, Message reads:
CENTER STOP INTERLOCK/!SERVICE OR CLEAR FAULT!
LEFT SIDE STOP/INTERLOCK/!SERVICE OR CLEAR FAULT!
RIGHT SIDE STOP/INTERLOCK/!SERVICE OR CLEAR FAULT!
LEFT DOOR STOP/INTERLOCK/!SERVICE OR CLEAR FAULT!
RIGHT DOOR STOP/INTERLOCK/!SERVICE OR CLEAR FAULT! ......................... 6-10
Unit Does Not Start, Message reads:
CIRCUIT BREAKER TRIPPEDSERVICE OR CLEAR FAULT
INVERTER OR MOTOR OVERLOADSERVICE OR CLEAR FAULT ........................ 6-10
Unit Starts, Then Shuts Down ...........................................................................................6-11
Unit Starts, Blank Message Screen ................................................................................. 6-12
Unit Is Running Normally Then Goes into Standby State
or
Unit Starts and Goes Immediately Into Standby State, Message reads:
IRONER/FOLDER NOT READY ............................................................................... 6-12
6.4 Mechanical
Noisy Operation ............................................................................................................... 6-13
Ribbon Set Not Working .................................................................................................. 6-13
Rotating Elements Stop ................................................................................................... 6-13
Machine Operation is Sluggish, Message reads:
AIR PRESSURE IS LO ............................................................................................. 6-13
6.5 Inlet Section
Inlet Conveyor Does Not Lift up to Space the Flatwork ................................................... 6-14
Flatwork Jams at Inlet Conveyor or Inlet Conveyor Stalls ............................................... 6-14
Machine Stops, Message Reads:
INLET TOUCH OR CROSSBEAMSERVICE OR CLEAR FAULT ............................. 6-14
Neither Side of Clutch/Brake Rollers Stop ....................................................................... 6-15
Clutch/Brake Rollers Stop Late; Corners Dropped; Corner Size Inconsistent ................. 6-15
Machine Stops, Message Reads:
CORNER CLUTCH JAMMEDSHUTDOWN BEFORE REMOVING ......................... 6-15
TOC INDEX