LOCATION AND FUNCTION OF PARTS AND
CONTROL OF MICROPNHONE (IWH-201)
1.Grille cover
2.Low battery indicator
The green LED showed the battery in full enough power.
The red LED showed the battery is weakly. Recharge the battery.
3.Power switch
Slide to turn microphone on.
4.Infrared emission source
Transmitting the infrared ray which carrying voice.
5.Power Selector Switch (Lo/Hi)
This switch changes transmitting power of infrared ray. At Lo position transmitting
distance is approx. 20M and at Hi position approx. 30M.
If transmission system may pick up some noise at Lo position.
It means the transmitting distance may be insufficient. Set the switch to Hi position.
Factory setting is Lo position.
At Hi power operation, operating time is approx. 4 hours.
(About half time of Lo power operation.)
Turn the battery cover to counterclockwise and pull out. As shown in figure.
Make sure the power switch is in the OFF position when replacement battery.
Make sure the battery polarity is correction when installation the new battery.
REPLACEMENT OF BATTERY(IWH-201)
CUSTOM MADE RECHARGEABLE Ni-MH BATTERY
1.This battery is exclusively designed for the infrared wireless microphone.
2.Be sure to charge the attached battery before use.
3.For surely you do not repeat recharge the battery before full discharge.
4.Keep clean the terminal of charge, otherwise you may not charge the battery.
5.Do not repeatedly recharge the battery before full discharge, if you repeat above,
battery life will shorter.
6.Battery life about 1 year or 500 recharge cycle under normal operation, when you
feel operating time became shorter even full charging, the battery is exhausted.
7.Replace with new battery.(Be sure to use exactly same type as attached.)
Continuous operating time of fully charger Ni-MH 2100mA/2.4v battery is as follows:
BATTERY OPERATING TIME
Hi position
Position of Power Selector Switch
Lo position
Operating time
6 hours
4 hours
2
3
BODYPACK IR TRANSMITTER FOR LAVALIER OR
HEADWORN MICROPHONE(IWM-202)
1
2
3
4
3
5
6
1.Open battery cover and put 2*AA alkaline batteries.
2.Connect with lavalier or headset microphone input.
3.Power on and power indicator turns green, if turn red or remain off it means no
power or power shortage. Please replace with new batteries. Generally two
alkaline batteries can last 5~6 hours in use.
4.Adjust amplifier volume control.
5.Not cover with infrared emission source anytime.
1.battery cover
2.battery set
3.lavalier or headset
microphone input
4.power
5.power indicator
6.infrared emission source
Note
The installation location
microphone direction and volume control
need to pay more attention not to result in sharp noise.